marshall9720 Posted April 28, 2021 Report Share Posted April 28, 2021 I have a J245 Jacuzzi and someone must gave twisted too hard on one of the jets and it came off. It seems as the plastic tubing that connects the jet cracked off and is stuck in the hole. How do I get it out? And do I just order a whole new jet? Picture is attached off the jet and the broken pieces. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted April 28, 2021 Report Share Posted April 28, 2021 Pair of needle nose plyers and spin what's left clockwise until it stops and then force it a little further and pull. You should be able to just buy the tail piece. Lot cheaper than a complete jet. Make sure to measure and get the right size as there are many. 1 Quote Link to comment Share on other sites More sharing options...
marshall9720 Posted April 29, 2021 Author Report Share Posted April 29, 2021 This may be a stupid question, but should I drain the water below the jet to take out the piece or can it be done without draining and just turning the power off? Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted April 29, 2021 Report Share Posted April 29, 2021 No need to drain. 1 Quote Link to comment Share on other sites More sharing options...
marshall9720 Posted April 29, 2021 Author Report Share Posted April 29, 2021 I am having trouble finding just the tail piece for a jet. Where would be a place I could look for that part? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.