IgorB Posted September 14, 2021 Report Share Posted September 14, 2021 Hello everyone, my problem is that my Gecko in.k600 control keypad's display went blank. After checking the cables still nothing, but I figured out, that if I turn off electricity to the spa for a couple minutes and turn back on, the display works again, but after some time (like 5 minutes tops) it fades out and goes blank again. Any ideas? Thanks Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted September 14, 2021 Report Share Posted September 14, 2021 Does the spa continue to run automated cycles (heat and filter)? Do the buttons work? If so, you probably just need a topside. @CanadianSpaTech, would you agree? Quote Link to comment Share on other sites More sharing options...
IgorB Posted September 14, 2021 Author Report Share Posted September 14, 2021 Just now, RDspaguy said: Does the spa continue to run automated cycles (heat and filter)? Do the buttons work? If so, you probably just need a topside. @CanadianSpaTech, would you agree? Yeah, everything works properly, buttons as well. just can't see anything on the display Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted September 14, 2021 Report Share Posted September 14, 2021 I'd say it's just the display, but @CanadianSpaTechis our gecko guru, so don't order one until he pipes in here. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted September 14, 2021 Report Share Posted September 14, 2021 As a guess I would say yes you need a topside. Post a photo of the topside so we can see condition. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.