ZachinSoDak Posted May 24, 2021 Report Share Posted May 24, 2021 I just bought a house and it has a hot tub by PDC. A water feature failed causing water to spray all over. There is power to the unit, but the pumps/jets do not operate. Any thoughts or suggestions? Thanks Quote Link to comment Share on other sites More sharing options...
Sandlotje Posted May 25, 2021 Report Share Posted May 25, 2021 Time to start the troubleshooting process. My experience is limited to my hot tub (Dream Maker), but yours should be similar I assume. Open the access panel to the "guts" of the spa. Locate the control pack that contains the control board. Take a picture of the wiring diagram and upload it here. (Learned that one from RDspaguy) And then if I were you, (with power off at the breaker) I'd unplug all cables plugged into the control circuit board, then plug them in one by one, restoring and disconnecting power between each test to see which component was affected by the water. Quote Link to comment Share on other sites More sharing options...
Sandlotje Posted May 25, 2021 Report Share Posted May 25, 2021 Oh, and see if you can locate and download the manual. There should be a troubleshooting section that might offer some help at the very least. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted May 25, 2021 Report Share Posted May 25, 2021 Did the spa pack get wet? Turn off main power and use a blow dryer to dry out the circuit board. Then let it sit for a period of time so that you are sure everything is dry. Test all fuses. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.