Mica Posted November 23, 2023 Report Share Posted November 23, 2023 I need a new motor but having trouble finding the right one. Quote Link to comment Share on other sites More sharing options...
cranbiz Posted November 24, 2023 Report Share Posted November 24, 2023 This one is close enough. it's a 4HP 2 speed pump. Your current pump is a 4.5hp +- 1/2HP https://www.amazon.com/2-Speed-Waterway-Discharge-Executive-3721621-13/dp/B00KYPVF50 Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted November 24, 2023 Report Share Posted November 24, 2023 @cranbiz note the wet end... looks like an Ultra Jet Ultima wet end. The link you provided should also work.. if there is play in the plumbing https://pool-spa-supplies.com/vico-ultima-4-hp-2-s-d-230v-12a-2-spd-13-3-7-amps-1014164-16394 https://www.hottuboutpost.com/balboa-vico-ultima-4hp-230v-pump-34-430-2512n-48fr-2-speed/ 1 Quote Link to comment Share on other sites More sharing options...
Mica Posted December 12, 2023 Author Report Share Posted December 12, 2023 Thank you both for the replies. Are there any special considerations since this is the pump responsible for circulating through the heater? Or will it work as long as the numbers match on amps, hp, etc. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted December 13, 2023 Report Share Posted December 13, 2023 17 hours ago, Mica said: any special considerations As long as you wire it up correctly you should not have any issues. Just make sure when you start up the spa it starts in low. If it starts in high then swap the red and black wires at the pump. One is high and one is low. If the back of the pump is hard to get at when installed test it before you install. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.