falconman13 Posted October 19, 2020 Report Share Posted October 19, 2020 Hello I have a Tiger River Begal spa. Everythign was waorking fine, but I had a small leak in the heater, I orderd new o rings, replaced them While replacing the heater i broke one of the wires on the flow sensor inside of the heater, ordered a replacement and installed it. Refilled the tub, No leaks, but it wont start up The recirc pump is working , I have flow through the heater, but the control panel is flashing "Power" I have no heater, and no jets. Any idea what I did wrong? I have read that the heater wont work if the flow is low, so I am assuming its a flow sensor issue but I dont userstand why the jets wont work Any help is appriciated Thanks Mike Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted October 19, 2020 Report Share Posted October 19, 2020 Remove the filter. Jump the pressure switch connection on the board. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.