culchie23 Posted September 28, 2020 Report Share Posted September 28, 2020 I ordered a cover lifter ( Cover Rock-it ) for my spa. It's been a week and still not shipped. I was hoping to have it before I needed to add water to my spa, as the lifter plates slide under the spa. But there's probably a chance the outside temp here might dip below freezing soon. So, my dumb question is..... How much water do I need in the tub to be able to power it up ?? I don't really want to fill it up and drain it and fill it up again within a week or so. And I figured, if there's still water in any of the lines, it would be in the lower part. I don't know how the cycles would be affected if it was at all possible. Any knowledge or other ideas would be appreciated. Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted October 1, 2020 Report Share Posted October 1, 2020 You must cover the filters with water or plug the filter pipe and fill the footwell knee deep or so. Quote Link to comment Share on other sites More sharing options...
culchie23 Posted October 1, 2020 Author Report Share Posted October 1, 2020 Thanks for the reply. Still no word on them shipping my lift. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.