Arctic_NC Posted April 8, 2020 Report Share Posted April 8, 2020 Evening, I have a slight mess up with my low speed capacitor. It went bad and I ordered a new one. I took photos of the unit as I was pulling it apart... but my phone croaked and I lost the photos. Now I have a new capacitor, and I’m 50% certain of the wiring for this cap. But is anyone familiar with the connectors for this pump. I’ll attach some pics of what I have. I think it plugs in to the small box left behind the high speed capacitor. Then screws down to the lower left ring connector point with the yellow wire. Or the lower right where it’s bonded to the top lug and tied with the high speed. Any help would be great. Thanks Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted April 8, 2020 Report Share Posted April 8, 2020 Not familiar with that motor. Is there a manufacturers label on the motor itself? Quote Link to comment Share on other sites More sharing options...
Arctic_NC Posted April 8, 2020 Author Report Share Posted April 8, 2020 1 hour ago, RDspaguy said: Not familiar with that motor. Is there a manufacturers label on the motor itself? Says it’s a E.M.G. motor. Made by a company in Italy. I’ll try to get a picture of the plate on it’s side. Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted April 8, 2020 Report Share Posted April 8, 2020 This help? https://www.hydrospares.co.uk/help-advice-centre/help-articles/pumps/pump-power-lead-wiring-instructions.htm Quote Link to comment Share on other sites More sharing options...
RDspaguy Posted April 8, 2020 Report Share Posted April 8, 2020 👍 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.