rgbraun1 Posted May 12, 2014 Report Share Posted May 12, 2014 My easy touch (remote and at the contol panel) shows my water temp at 115. I went into service mode and then settings, calibration and changed water temp to 73 (what my floating thermometer read). The ln backed out of the menu and the temp sid not "stick"...it was back to 115 on remote and at contol panel. Any help? Quote Link to comment Share on other sites More sharing options...
ps0303 Posted May 16, 2014 Report Share Posted May 16, 2014 Try a power reset first and then change the temp. How old is your system? Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted May 16, 2014 Report Share Posted May 16, 2014 Before you buy a new sensor, try switching the air sensor with the water and see if the reading is still out of wack. You don't need to move the sensors, just switch the connections at the board. Quote Link to comment Share on other sites More sharing options...
rgbraun1 Posted May 16, 2014 Author Report Share Posted May 16, 2014 Ps0303-its about 8 years Pool clown- i'll give it a shot and reply results. Thanks for some leads Gb Quote Link to comment Share on other sites More sharing options...
rgbraun1 Posted May 17, 2014 Author Report Share Posted May 17, 2014 So the temps reversed. 'Air' on remote and control panel say 130, pool says 70. Where can I get new sensors? Can I leave the sensors switched at the panel until I get a new one? Quote Link to comment Share on other sites More sharing options...
Pool Clown Posted May 18, 2014 Report Share Posted May 18, 2014 Yes, you can keep them reversed. The air sensor is needed for the freeze protection. Don't think you will need that for at least a few months. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.