Water Temp Calibration W/ Easy Touch

[rgbraun1]

My easy touch (remote and at the contol panel) shows my water temp at 115. I went into service mode and then settings, calibration and changed water temp to 73 (what my floating thermometer read). The ln backed out of the menu and the temp sid not "stick"...it was back to 115 on remote and at contol panel.

Any help?

[ps0303]

Try a power reset first and then change the temp. How old is your system?

[Pool Clown]

Before you buy a new sensor, try switching the air sensor with the water and see if the reading is still out of wack. You don't need to move the sensors, just switch the connections at the board.

[rgbraun1]

Ps0303-its about 8 years

Pool clown- i'll give it a shot and reply results.

Thanks for some leads

Gb

[rgbraun1]

So the temps reversed. 'Air' on remote and control panel say 130, pool says 70.

Where can I get new sensors? Can I leave the sensors switched at the panel until I get a new one?

[Pool Clown]

Yes, you can keep them reversed. The air sensor is needed for the freeze protection. Don't think you will need that for at least a few months.