Lee C Posted January 3, 2022 Report Share Posted January 3, 2022 I have had a Bullfrog A6L for a few months now. Have a few questions for fellow Bullfrog owners. 1) The pump seems to run very often, and is quite loud. Is this normal? Is this a setting thing? Could this be an insulation thing? I am in NC so it is relatively warm. 2) I have the 2nd pump option. However, the pressure of the 2nd pump in 2 of the jetpacks is way stronger than the other 2 jetpacks. For those who have 2 pumps, have you had the same experience? Thoughts? Experiences? Quote Link to comment Share on other sites More sharing options...
CanadianSpaTech Posted January 3, 2022 Report Share Posted January 3, 2022 7 hours ago, Lee C said: The pump seems to run very often Check your filter cycle duration. Most spas will run a 2 hour filter cycle in AM and 2 hours in the PM. If you are in a warmer climate you can try an "Economy" mode so the heater only turns on during the filter cycles. 7 hours ago, Lee C said: and is quite loud Open the panel and make sure the wiring is not up against anything and causing vibration. Put your hand on each component to see if you can dampen any vibration. I don't see a lot of Bullfrog Spas here in Canada so can't comment on pump pressure. 1 Quote Link to comment Share on other sites More sharing options...
Lee C Posted January 4, 2022 Author Report Share Posted January 4, 2022 Thanks, CanadianSpaTech! I will check those things out. Quote Link to comment Share on other sites More sharing options...
Lee C Posted January 6, 2022 Author Report Share Posted January 6, 2022 I also have the thermal blanket in my spa that sits on top of the water, but because the jets turn on when the pumps run it usually gets crumpled up. Any ideas on keeping this in place on top of the water? Quote Link to comment Share on other sites More sharing options...
CanadianRodder Posted February 18, 2022 Report Share Posted February 18, 2022 Lee, did you solve your "loud" issue? I have an A6 (just north of Toronto. Frank Quote Link to comment Share on other sites More sharing options...
AliciaAnne85 Posted September 8, 2022 Report Share Posted September 8, 2022 We have an A6 that was loud. It ended up being an easy fix. We found that one of the pipes was touching something and causing a loud vibration. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.