jetch Posted July 23, 2013 Report Share Posted July 23, 2013 I recently installed a Pentair easy touch control panel and got the pump and salt generator automated. now i'm trying to get the lights automated and need guidance on the correct wiring within the GFCI box. To be clear, I can figure out the wiring in the Pentair load center, my question is specific to the GFCI box. I have an older pool so the GFCI box leads to an underground wire to the side of my house where there's an on/off switch. So the switch on the side of the house currently controls the lights. How should the wiring be configured in the GFCI box to allow for automation? The part that's confusing me is the switch on the side of the house and how that should be wired to allow for automation from a control panel back by the GFCI box (and pool equipment). Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.