Jump to content

Should I Be Concerned About Heavy Snow On Mesh Liner?


jkusmier

Recommended Posts

  • 4 weeks later...
  • 5 weeks later...
Definetly forget about it. A horse can walk on one of those covers. Besides, with the weight so evenly distributed over the surface, the cover probably scarely knows there's anything there.

How far down is the pool's water line? It should not exceed 18 inches. After that, the snow load should sit in the water and snow floats. An empty pool will pull the cover too much and can tear the straps off the springs and go in the pool.

Link to comment
Share on other sites

Definetly forget about it. A horse can walk on one of those covers. Besides, with the weight so evenly distributed over the surface, the cover probably scarely knows there's anything there.

How far down is the pool's water line? It should not exceed 18 inches. After that, the snow load should sit in the water and snow floats. An empty pool will pull the cover too much and can tear the straps off the springs and go in the pool.

Poolguy, I don't understand your reasoning. The way a safety cover works is that it is anchored to the floor around the edge of the pool. All of the tension is on the springs and anchors outside of the pool. A low water level or empty pool cannot hurt the cover one single bit.

Link to comment
Share on other sites

Definetly forget about it. A horse can walk on one of those covers. Besides, with the weight so evenly distributed over the surface, the cover probably scarely knows there's anything there.

How far down is the pool's water line? It should not exceed 18 inches. After that, the snow load should sit in the water and snow floats. An empty pool will pull the cover too much and can tear the straps off the springs and go in the pool.

Poolguy, I don't understand your reasoning. The way a safety cover works is that it is anchored to the floor around the edge of the pool. All of the tension is on the springs and anchors outside of the pool. A low water level or empty pool cannot hurt the cover one single bit.

No, not quite. Water must be no more than 18" below in order to support a snow load. The straps will let go of the springs otherwise. I have also seen covers tear. A safety cover is not considered safe by ASTM if the pool is too low or empty. No manufacturer will warranty or accept liability for a cover in that situation.

Since water weighs 7 lbs/gallon, it'll only take 500 gallons to get to a cover's break point. A wet snow fall or accumulation of about 10 inches on the cover will get you there. On top of that, as the cover sags, the snow on the edges may slide toward the center of the cover, concentrating the load. More tension in a smaller area is not a good thing. With water in the pool, the snow may float or if the pool is frozen, it will rest on the ice.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...