Smores Posted October 23, 2019 Report Share Posted October 23, 2019 Just hooked up my grandee out of storage , been in storage 2 years anyway I wired it all up I’m an electrician by trade and the 20a breaker turns on but the 30a breaker won’t reset I disconnected everything from the main board with no luck, motors ,heater, ozone, verified the power is good to the tub , anyone have any suggestions , main board maybe ,relay board Quote Link to comment Share on other sites More sharing options...
Hot Spring Official Posted October 23, 2019 Report Share Posted October 23, 2019 You did not give a serial number, but for the last 15 years the 30 amp breaker control the spa side, not the heater side. Where is you neutral wire in you sub panel? It need to be on the load side of the breaker and not the neutral bar. Quote Link to comment Share on other sites More sharing options...
Smores Posted October 23, 2019 Author Report Share Posted October 23, 2019 Sorry ,the serial number is GG3R1175 so your saying to tie the neutral from the main panel directly into the neutral going to the tub ? Bypassing the neutral bar completely Quote Link to comment Share on other sites More sharing options...
Smores Posted October 23, 2019 Author Report Share Posted October 23, 2019 Thanks in advance Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.