Wickedhahdmg1690 Posted March 1, 2019 Report Share Posted March 1, 2019 Picked up a FREE 2001 bengal m. Followes atart up procedures per the manual. All jets work, panel works just keep getting a blinking ready light after about 5-15 minutes. Steps taken so far: 1 Reset GFCI plug and wait then start over per manual. checked for airlock free flowing. Diconnected the hose from heater outlet back to tub and it comes out hot, which I believe means Circulation pump and heater are working...... Any ideas? Quote Link to comment Share on other sites More sharing options...
Jwyrick85 Posted March 1, 2019 Report Share Posted March 1, 2019 Remove the filter and try again. If that doesn't help and you're sure you have good flow from the circulation pump back to the tub, you're probably looking at a bad thermistor. Quote Link to comment Share on other sites More sharing options...
Hot Spring Official Posted March 1, 2019 Report Share Posted March 1, 2019 Ready light will blink because of the control thermistor. Make sure it is connected properly and has the same ohm value as the hi-limit thermistor. Quote Link to comment Share on other sites More sharing options...
Wickedhahdmg1690 Posted March 1, 2019 Author Report Share Posted March 1, 2019 1 hour ago, Hot Spring Official said: Ready light will blink because of the control thermistor. Make sure it is connected properly and has the same ohm value as the hi-limit thermistor. Process and location of testing?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.