Bankerboy72 Posted November 21, 2017 Report Share Posted November 21, 2017 I purchased the tub from a friend a few years ago and finally finished my patio and installed tub. When I first filled the heater end was cracked and I needed a new heater. Upon receipt I installed and filled again and tried to power up only to have the LED display flashed erratically. I ordered a new control head and display. When I attempted to power up I have no lights on the display and the mother board just hums. Thinking that I need a new motherboard but would appreciate some expert guidance so I don't throw good money after bad. The panel is an IQ2020. Should you need anything else just ask. Just a do it yourself home owner watching my coins. I can email pics of board if necessary as they were too large to post. Quote Link to comment Share on other sites More sharing options...
Jersey Hot Tub Repair Posted November 23, 2017 Report Share Posted November 23, 2017 Do you know that your electrical source is connected properly? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.