Delgado Posted May 16, 2012 Report Share Posted May 16, 2012 I resently cleared my memory on the display to add my own programs and now my in floor system is not turning on , I went on system setup then in floor cln and turned it on and nothing but I also noticed my filter pump has 20 lbs is pressure way above normal if I clean my filter will that turn it on Quote Link to comment Share on other sites More sharing options...
PoolGuyNJ Posted May 17, 2012 Report Share Posted May 17, 2012 You have what type of equipment? Scott Quote Link to comment Share on other sites More sharing options...
Delgado Posted May 20, 2012 Author Report Share Posted May 20, 2012 Jandy rs6 control sta rite 400 pump and cleartaker floor system Quote Link to comment Share on other sites More sharing options...
Delgado Posted May 20, 2012 Author Report Share Posted May 20, 2012 Care taker 99 also the transition indicator is flashing and the floor system is not popping up normally only for a second then switches to the next Quote Link to comment Share on other sites More sharing options...
Delgado Posted May 20, 2012 Author Report Share Posted May 20, 2012 Omg aqualink rs6 Quote Link to comment Share on other sites More sharing options...
PoolGuyNJ Posted May 22, 2012 Report Share Posted May 22, 2012 RS-6 was what I needed. Sounds like the valve actuator isn't programmed. I would expect it to be #3. Label it in the RS and assign it a time period when the pump is on. Scott Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.