bprice Posted May 6, 2012 Report Share Posted May 6, 2012 I am helping a friend replace his spa pack, I am very familar with installing these types of packs I have installed several of them before but we specifically asked for a spa pack set up with a 220 volt circulator pump and they sent the pack set up for a 120 volt circulator pump. When I contacted them about it they said it can be used for either but you have to have a certified spa tech contact balboa for the jumper wire conversion and will no accept a return because we have already installed the pack. Can someone please direct me to where to move the jumper wires to convert the circulator pump to 240 volt? The cover of the pack shows how to covert the blower/ozone from 120 v to 240 volt but no diagrahm for the circulator pump. Thanks in advance for the help!!!!! Quote Link to comment Share on other sites More sharing options...
n1oty Posted May 6, 2012 Report Share Posted May 6, 2012 I am helping a friend replace his spa pack, I am very familar with installing these types of packs I have installed several of them before but we specifically asked for a spa pack set up with a 220 volt circulator pump and they sent the pack set up for a 120 volt circulator pump. When I contacted them about it they said it can be used for either but you have to have a certified spa tech contact balboa for the jumper wire conversion and will no accept a return because we have already installed the pack. Can someone please direct me to where to move the jumper wires to convert the circulator pump to 240 volt? The cover of the pack shows how to covert the blower/ozone from 120 v to 240 volt but no diagrahm for the circulator pump. Thanks in advance for the help!!!!! It's the same as for blower or ozone. Move the neutral conductor for that circuit to "Red AC" for 240 volt operation. John Quote Link to comment Share on other sites More sharing options...
bprice Posted May 7, 2012 Author Report Share Posted May 7, 2012 Thank you for the reply and I had thought that too and it does not work. I tries it and the circulator pump does not come on, tested the pump and the pump works fine even switched the jumpers back to the original spot and tried that to see if it was something else and the pump tries to work but of course does not have the correct power so the motor just surges. So when I switches the white wire/neutral to red 240 just as the diagram explains for the blower the motor does not power on. Any other suggestions? Thanks again Quote Link to comment Share on other sites More sharing options...
bprice Posted May 7, 2012 Author Report Share Posted May 7, 2012 Any body else have a suggestion on this? Quote Link to comment Share on other sites More sharing options...
bprice Posted May 8, 2012 Author Report Share Posted May 8, 2012 Ok found out it did not go to the red 240 it goes to black 240 j17 now we have another prob I wi start another tooc In it thanks for ur suggestions Quote Link to comment Share on other sites More sharing options...
doghousedoggy Posted September 4, 2012 Report Share Posted September 4, 2012 wiring schematic is available, balbo can email it. the wiring can get confusing, green black red white i found when switching ozone from 120 to 240 the pin postion on plug from device must be change to match wiring from the board (plug) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.