cowardlycoyote Posted November 8, 2010 Report Share Posted November 8, 2010 I've had my Soft Tub for a little over 5 years. It worked well for about 4.75 yrs, then quit. I took it to a dealer who got it going again (for $700) 2 months, and now it has quit again. I don't have much faith in going back there. I'm pretty handy. Does anyone know where I might get a manual with an electrical diagram for a T 300? The tub is in good shape and all the jets were functioning. The panel is now black, though it's still getting juice from the outlet. Reset does nothing. Thanks. Quote Link to comment Share on other sites More sharing options...
n1oty Posted November 8, 2010 Report Share Posted November 8, 2010 I've had my Soft Tub for a little over 5 years. It worked well for about 4.75 yrs, then quit. I took it to a dealer who got it going again (for $700) 2 months, and now it has quit again. I don't have much faith in going back there. I'm pretty handy. Does anyone know where I might get a manual with an electrical diagram for a T 300? The tub is in good shape and all the jets were functioning. The panel is now black, though it's still getting juice from the outlet. Reset does nothing. Thanks. I did factory work for them for a few years and I never saw any schematics. Then again, there is so little to the Softub boards that you don't really need a schematic. If your display is dead and the motor is not running, I'd suspect the cord end GFCI first, followed by a board fuse or a bad board. John Quote Link to comment Share on other sites More sharing options...
Ponybill Posted July 6, 2020 Report Share Posted July 6, 2020 HI John, do you at least have a picture possibly of the board wired up? I am replacing my girlfriend's T300 pump with a new one and forgot to take pics of how it was wired. Thanks in advance! Bill Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.