seabright_sc Posted January 8, 2010 Report Share Posted January 8, 2010 New owner here.... I just purchased a 1996 Hotspring Prodigy for my wife that appears to be in really clean condition. The shell is immaculate, redwood skirt refinished, and comtrol compartment very clean. I bought it off Craigslist from a guy who refurbishes, delivers, and offers a warranty. The spa was up and running when I purchased it and it is currently empty at my house as we are reinforcing the deck that it will be placed on this weekend. When the tub was delivered (and up on it's side), I noticed that some of the foam insulation on the bottom was ripped out. It appeard to be about mayby 9-12 inches in diameter and an inch or two thick. There appeared to to no water damage and when I asked the man who sold me the spa, he said it may have been torn during delivery at some point. It didn't look major, but was clearly noticable. So... does this warrant concern or repair? Id so, how should I repair it? We live in the mild climate of the Central California coast and the hot tub will be set on a deck raised above the ground. Thanks! Quote Link to comment Share on other sites More sharing options...
djousma Posted January 8, 2010 Report Share Posted January 8, 2010 New owner here.... I just purchased a 1996 Hotspring Prodigy for my wife that appears to be in really clean condition. The shell is immaculate, redwood skirt refinished, and comtrol compartment very clean. I bought it off Craigslist from a guy who refurbishes, delivers, and offers a warranty. The spa was up and running when I purchased it and it is currently empty at my house as we are reinforcing the deck that it will be placed on this weekend. When the tub was delivered (and up on it's side), I noticed that some of the foam insulation on the bottom was ripped out. It appeard to be about mayby 9-12 inches in diameter and an inch or two thick. There appeared to to no water damage and when I asked the man who sold me the spa, he said it may have been torn during delivery at some point. It didn't look major, but was clearly noticable. So... does this warrant concern or repair? Id so, how should I repair it? We live in the mild climate of the Central California coast and the hot tub will be set on a deck raised above the ground. Thanks! I would not worry about it. Quote Link to comment Share on other sites More sharing options...
spatech (the unreal one) Posted January 8, 2010 Report Share Posted January 8, 2010 When the tub was delivered (and up on it's side), I noticed that some of the foam insulation on the bottom was ripped out. It appeard to be about mayby 9-12 inches in diameter and an inch or two thick. So... does this warrant concern or repair? Id so, how should I repair it? We live in the mild climate of the Central California coast and the hot tub will be set on a deck raised above the ground. Thanks! I'd be concerned if there is any chance rodents can get under it. While its only an inch or two deep and shouldn't effect insulation much, especially where you live, you do not want anything nesting in there. If you talk to a local Hot Spring dealer you can see about getting what they use (a simple to use type of 2-part epoxy) when they have to replace that hardcoat on the bottom. Quote Link to comment Share on other sites More sharing options...
seabright_sc Posted January 8, 2010 Author Report Share Posted January 8, 2010 When the tub was delivered (and up on it's side), I noticed that some of the foam insulation on the bottom was ripped out. It appeard to be about mayby 9-12 inches in diameter and an inch or two thick. So... does this warrant concern or repair? Id so, how should I repair it? We live in the mild climate of the Central California coast and the hot tub will be set on a deck raised above the ground. Thanks! I'd be concerned if there is any chance rodents can get under it. While its only an inch or two deep and shouldn't effect insulation much, especially where you live, you do not want anything nesting in there. If you talk to a local Hot Spring dealer you can see about getting what they use (a simple to use type of 2-part epoxy) when they have to replace that hardcoat on the bottom. Not really any chance of rodents entering that area. Though I did, upon very close inspection, notice some rodent droppings in the equipment compartment with a bit of chewed up foam from long ago. No wire damage and the critters are long gone. Hope they didn't cause too much damage! Quote Link to comment Share on other sites More sharing options...
masanori Posted January 8, 2010 Report Share Posted January 8, 2010 When the tub was delivered (and up on it's side), I noticed that some of the foam insulation on the bottom was ripped out. It appeard to be about mayby 9-12 inches in diameter and an inch or two thick. So... does this warrant concern or repair? Id so, how should I repair it? We live in the mild climate of the Central California coast and the hot tub will be set on a deck raised above the ground. Thanks! I'd be concerned if there is any chance rodents can get under it. While its only an inch or two deep and shouldn't effect insulation much, especially where you live, you do not want anything nesting in there. If you talk to a local Hot Spring dealer you can see about getting what they use (a simple to use type of 2-part epoxy) when they have to replace that hardcoat on the bottom. Not really any chance of rodents entering that area. Though I did, upon very close inspection, notice some rodent droppings in the equipment compartment with a bit of chewed up foam from long ago. No wire damage and the critters are long gone. Hope they didn't cause too much damage! If you want you can buy a can of polyurethane foam at Lowes or Home Depot for the touch up. I actually develop Polyurethane Insulation. A small chunck is nothing to worry about. Most rodents will not eat or live in the foam. Quote Link to comment Share on other sites More sharing options...
spatech (the unreal one) Posted January 8, 2010 Report Share Posted January 8, 2010 Not really any chance of rodents entering that area. Though I did, upon very close inspection, notice some rodent droppings in the equipment compartment with a bit of chewed up foam from long ago. No wire damage and the critters are long gone. Hope they didn't cause too much damage! With the door closed, look for any gaps where rodents could get in the equipment area and seal them up. Since the spa is not running, you could turn it on its side so you can look at the underside where the door attaches and inspect closely for gaps which is easier to do in that position. Mice can get in openings the size of a dime. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.