TideJoe Posted November 9, 2009 Report Posted November 9, 2009 I can see in the pre-delivery instructions that the electrical cutout is 49" from the right (on the control panel side). My question is, how far back (deep) does the cutout start from the edge (the floor support on the wall the control panel is on)? I want to make sure I stub the conduit up in the right spot. Thanks Quote
Peteyboy Posted November 9, 2009 Report Posted November 9, 2009 The cut-out itself is 1 3/4" wide and 3/4" deep from the front of the base wood to the back of the cut-out. We advise people not to use more than 3'4" conduit. Quote
TideJoe Posted November 9, 2009 Author Report Posted November 9, 2009 The cut-out itself is 1 3/4" wide and 3/4" deep from the front of the base wood to the back of the cut-out. We advise people not to use more than 3'4" conduit. So the outer most edge of the cutout starts at the outer edge of the base wood and is 3/4" deep? Quote
Peteyboy Posted November 10, 2009 Report Posted November 10, 2009 Correct - if you use no more then 3/4" conduit it won't hit the door - 1" can bulge the door a little. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.