Dongle Squares Posted April 3 Report Share Posted April 3 So I'm repairing a flair hot tub... So far I've installed a new board and hooked up only the heater and the top side panel. The box needs to be updated I know that but, something odd happened where the heater immediately turned on and began over heating. I've never seen that before, is that normal? What could cause the heater to just turn on and run dry with a new board? Sensors being bad? Quote Link to comment Share on other sites More sharing options...
.thumb.jpg.dc5a6170fa916412670749ff27e20047.jpg)
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.