Water pump- not turning on, test with out wires connected

[Eddieba]

Balboa board m2/m3 and top controller,

The hot tub was working just fine till last night. While I was in it a compression coy-long come off, so I killed it at the breaker and reconnected the coupling and left it off until this morning.

i went to go turn on and the board would turn on and click but nothing happened.

So i started testing connections....

2 speed 240v gecko motor

When I test the output to the water pump1 while connected to the board I get no readings.

when I disconnect the pump from the board and retest the out on the board I’m getting 240v from white to red and 120 from white to black(second stage)

i tested the capacitor on pump and getting the 15 mF that is stated on label.

Is the pump grounding out? Any suggestions? Thoughts?

Thanks for any advice.