dwise Posted June 16, 2019 Report Share Posted June 16, 2019 I have a Spaguts vs500z control pack made by Balboa. Recently I replaced my heating element and just had to replace my 4 HP motor. (with a Waterway Executive 56-frame dual speed pump 3721621-1D) The previous 5 year old motor starting failing repeatedly and I replaced the capacitor once. The new motor is working fine and the tub heats up. However, it is not shutting off. Previously the board would cut off about 104. Yesterday it ran until 108 and I had to cut the breaker. The temp sensors seem to be connected correctly into the board and into the heater. Any ideas on what to do now? The new motor shouldn't have anything to do with this right? Link to photos of my board, heater, etc located here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.