kartwood Posted August 13, 2017 Report Share Posted August 13, 2017 Hi folks,! We have a 580 which was purchased new in 2000. It has a Balboa DU2500ES control system. It has been mothballed for the past couple of years and I am trying to get it going again. I have replaced the nozzles and most of the plumbing. It was filled with water yesterday. On power up, it starts to heat with the pump on low. Temp is indicated. I can turn the light off and on but cannot set the temp or select high pump. It's like those buttons just do nothing. I fooled the tub sensor into thinking water was at 100 F and the heater turns off as does the pump. I cleaned the RJ45 connector going to the panel and soon after the pump shifted to high but I still had no control and had to power down. Any thoughts? Thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.