cappy813 Posted August 27, 2015 Report Share Posted August 27, 2015 replaced my cell and sensor. While replacing i noticed that the new sensor had only 2 contacts and my old one had 3 contacts on the bottom (do the new sensors only have 2?), also the DC power cable that came with the new cell had two wires (blue and red) while my old one had 3 wires (black, white and green the black and white wires were connected to a single push on connector), I connected the blue wire to same connection where the black and white were connected and the red wire to where the green wire was connected, hope this right. I replaced both the cell and sensor and reconnected to the aquapure control center. Everything seems to be working OK, except that i haven't seen that the reverse cell light ever goes off. Is this normal? Any thoughts/comments Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.