cappy813

replaced my cell and sensor. While replacing i noticed that the new sensor had only 2 contacts and my old one had 3 contacts on the bottom (do the new sensors only have 2?), also the DC power cable that came with the new cell had two wires (blue and red) while my old one had 3 wires (black, white and green the black and white wires were connected to a single push on connector), I connected the blue wire to same connection where the black and white were connected and the red wire to where the green wire was connected, hope this right. I replaced both the cell and sensor and reconnected to the aquapure control center. Everything seems to be working OK, except that i haven't seen that the reverse cell light ever goes off. Is this normal? Any thoughts/comments

replaced my cell and sensor. While replacing i noticed that the new sensor had only 2 contacts and my old one had 3 contacts on the bottom (do the new sensors only have 2?), also the DC power cable that came with the new cell had two wires (blue and red) while my old one had 3 wires (black, white and green the black and white wires were connected to a single push on connector), I connected the blue wire to same connection where the black and white were connected and the red wire to where the green wire was connected, hope this right. I replaced both the cell and sensor and reconnected to the aquapure control center. Everything seems to be working OK, except that i haven't seen that the reverse cell light ever goes off. Is this normal,