gokiljerry Posted March 25, 2014 Report Share Posted March 25, 2014 I have a Dream Maker Eclipse spa that is about 10 years old. It is leaking terribly around the shaft seal. I know I need to remove the pump. However, it looks like a near impossible task to get to the screws on the mounting bracket. Any suggestions? Quote Link to comment Share on other sites More sharing options...
delaware74b Posted March 26, 2014 Report Share Posted March 26, 2014 I just did this over the weekend. Loosen the water lines on the pump after draining the hot tub. Lift the tub up and prop it on 2 4x4's. Reach under with a 7/16" socket & ratchet and hold the nuts by the motor with a 7/16" wrench. My pump wasn't leaking, the motor's sleeve bearing on the bell end went bad and locked up the motor on start-up. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.