WalkerC Posted October 21, 2010 Report Share Posted October 21, 2010 Hello from Indiana. I have an old spa I'm rebuilding. It has two jets right next to each other down in the bottom where your feet go. They are made by Waterway. One of them has an air hose barb built into it and the other does not. I can find the replacement for the one with the air hose barb, (part # 211-0300, assy # 210-033) but the other one doesn't show up in my searches. It's Waterway part # 211-8300. It's the same as the other, but instead of a hose barb coming out the side it has about a 1" (plugged) outlet. Is there any reason I couldn't just use two of the type with the air hose barb on the side? I figure I could just use a T or a Y to split the air line and run it to both. Or is there another jet that would work as well? Thanks in advance for entertaining a beginner. Walker Quote Link to comment Share on other sites More sharing options...
Pathfinder Posted October 21, 2010 Report Share Posted October 21, 2010 There's no reason you cant use the the same jet body & add another air line. Quote Link to comment Share on other sites More sharing options...
NccPools Posted October 21, 2010 Report Share Posted October 21, 2010 2010 waterway book does not show 211-8300. might be a part designed for that spa only. No problem the 1 inch line is usually for a air line(ex. 1" flex pvc or 3/4" flex) if you dont use this outlet then you can plug it off. the part number 211-0300 is an ozone jet and that is why it has a barb connection. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.