E2Grunt Posted April 10, 2009 Report Share Posted April 10, 2009 I have a jandy aqualink system. The booster pump has been truning on in the evening and the panel in the house shows that everything is off. I have to shut down and reset the system to turn it off at that point. Today it came on did the same thing at a different time. Someone told me to try taking the remote spa switch out of the circuit, I did that and it still malfunctioned. What else could I look at to diagnose the problem? Quote Link to comment Share on other sites More sharing options...
nc/sc poolboy Posted April 10, 2009 Report Share Posted April 10, 2009 I have a jandy aqualink system. The booster pump has been truning on in the evening and the panel in the house shows that everything is off. I have to shut down and reset the system to turn it off at that point. Today it came on did the same thing at a different time. Someone told me to try taking the remote spa switch out of the circuit, I did that and it still malfunctioned. What else could I look at to diagnose the problem? Quote Link to comment Share on other sites More sharing options...
nc/sc poolboy Posted April 10, 2009 Report Share Posted April 10, 2009 Take note of all wanted programs, spa switch settings, labels and temp settings. Then CLEAR MEMORY and reprogram. If this doesnt work plug the booster pump relay into another available aux. If one is not avail., replace relay drivers on pcb. (unlikely). Quote Link to comment Share on other sites More sharing options...
E2Grunt Posted April 10, 2009 Author Report Share Posted April 10, 2009 Is there a way to put a meter on the relay or other equipment to check it rather than the wait and see method? Thanks Quote Link to comment Share on other sites More sharing options...
AquaTechPool Posted April 12, 2009 Report Share Posted April 12, 2009 these symptons are typical of the spa side remote malfunction. how did you take the remote out of the circuit??? Quote Link to comment Share on other sites More sharing options...
E2Grunt Posted April 20, 2009 Author Report Share Posted April 20, 2009 these symptons are typical of the spa side remote malfunction. how did you take the remote out of the circuit??? I disconected it at the panel outside. I was reading the manual on the unit. Would a bad backupbattery cause this? I tried clearing all old programs but it seems to still retain part of them. Quote Link to comment Share on other sites More sharing options...
E2Grunt Posted May 12, 2009 Author Report Share Posted May 12, 2009 Got on the phone te other day with Jandy tech support and determined it was the PCB. So, it's not going to be a cheap fix. But at least I know what it is now. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.