Search the Community
Showing results for tags 'dream maker spa'.
-
I was gifted a 4 person ez-spa by Dream Maker, it is a little bit older and has been sitting for a couple of years without running. We cleaned it up really nice and plugged it in for a test drive and it kept tripping the breaker. After watching a few videos on you tube, and by the looks of it, I believe I need a new pump. My question is, does this type of spa require a heating element/sensor or does it require a heating pump? This is what everything looks like. It appears to me that there is not an additional heating element, just the pump, but when I look at the control panel, the circuit for OZONE is missing. So, I am left wondering if this a missing part or if all I need to do is replace the pump and that's what would control the heating of the spa as well. What do I need to buy? I've looked up several pumps but am confused on what would work best for this model of spa. Any advice would help, I am just trying to figure out how to get this spa up and running so I can enjoy it!!
- 1 reply
-
- heating element
- pump
-
(and 3 more)
Tagged with:
-
I’ve had a dreammaker 400x for a few years now with no issues. It’s 110v plug in and recently it has been overheating and gets an OH alarm on controller it will run a day or so then shuts down and gets ice cold until I reset the controller. I’ve went thru the basics changed the filter, made sure pump doesn’t have air in it, temp is actually extremely hot. I have good flow out of the jets and it 30 degrees out so outside influence is not the issue. I’ve read a few forums people have had same issue but no one ever seem to post how they fix the problem. Im leaning towards a relay on the board that’s not open when heat is not called. Not sure if anyone has had any luck fixing this issue.
-
Hi Everyone, looking for some help. My hot tub display dropped to 60. When I unplug it and plug it back in it starts at 100 and slowly works it way back down to 60. When I try to press the buttons up the temp just falls back down to 60. It still feels pretty warm in the tub but not 104 that’s for sure. I’m worried because it’s so cold here right now and won’t warm up for months, it’s -4 f here right now. I think it could be the topside display? Any thoughts? Additional information it’s a 2007 x400 dream maker spa. Thank you so much Erika
- 1 reply
-
- dream maker spa
- topside
-
(and 2 more)
Tagged with: