Grant D

Interesting, and a learning experience, the start cap/centrifugal switch was off kilter enough to not close the circuit. Once i realized that, and re set the mount and aligned it properly, everything is back to normal. (after testing every circuit, and switch etc. for continuity, replacing a suspect wire etc....) Thanks for your response, much appreciated. GD

Good idea! Over the last couple of years i have had trouble with it failing to start automatically at low speed. I can start it at high speed and then turn it down. I've replaced the switch and the capacitor a couple of times, which works short term but the issue keeps coming back. What do i need to rebuild it? Do you sell a rebuild kit?

I'm in a similar situation I have a Djayea 0153 pump that is rated 115v 10.4/3.6 Amps (pics attached)looking to replace my pump with a pump that is 115v 13.0A/3.7A is this too big a jump in the hi speed amperage? Or would it still be ok? Here is a link to the new pump https://www.hottuboutpost.com/sta-rite-dura-jet-pump-239113-s-1-5hp-115v-2-speed-2-inch/