sllimphil

I have same problem on my TX. Dots & dashes. Cold water. Pump running 24/7. Saw video where guy disconnected pressure switch and put screwdriver across contacts for 20 seconds. If 'heat' light comes on you know its pressure switch. Now someone said that test could ruin heater!. If 'heat' light comes on is that proof heater still good or just that heater is needed? Thanks

Hi all, problem now solved. Mice have been nibbling the insulation and the hose going to the comfort control valve has sucked a load of foam bits up blocking it. Sucked out loads of bits, assembled and now working properly again. Air hose is now off the base so hopefully won't suck any crap into it!!

So I've removed the flexible arm and air pipe again. Held it up and it hangs straight. Switched on and turned air valve to full. Air or water gushes from large hole where the vertebrae bit screws in. Put my finger over the air nozzle and cannot feel anything. Should I be able to feel air coming out? (Or sucking in?). Thanks

Thanks Ratchett. Already tried with filter out, no change. Air control knob appears to work fine. Turning fully on increases power in all jets including MM.

Hello. I have a hotsprings solana RX. The mice have eaten their way through this concertina tube. Its behind the pcb board. What is its purpose please? Feels like it goes to a vent underneath. Thank you

Hello, I have a hotsprings rx tub. The moto massage stopped working so I ordered a new flexible jet and fitted it according to the included instructions and YouTube videos. The arm does not go up and down as expected on full blast. All the 'experts' keep telling me is how to fit it and to line up the dots (vertical). I've read a few threads on here, but they seem to be more about no air coming through. Mine has a strong jet. Can anyone on here shed any light please? Thank you