[Gecko IN.XE spa pack, Stuck in Boot Up, low voltage power supply?]

@CanadianSpaTech

I replace the capacitor 5600UF 25V.  Replaced by PANASONIC EEU-HD1E562 @ 4$ + 8$ shipping.

https://www.digikey.ca/en/products/detail/panasonic-electronic-components/EEU-HD1E562/2796102

 

[Gecko IN.XE spa pack, Stuck in Boot Up, low voltage power supply?]

It is repaired!

i replaced part on the mother board.

😁

[Gecko IN.XE spa pack, Stuck in Boot Up, low voltage power supply?]

I tested the low voltage power supply and it's not the problem.

SEC 10V:  I read at the output of the connector 9V (I think it's good)

SEC 12V:  I read at the output of the connector 11V. (I think it's good)

How do you know if the keypad control that is the issue?

⁉️

[Gecko IN.XE spa pack, Stuck in Boot Up, low voltage power supply?]

I have a dynasty spas with a Gecko in.XE 5-11-H4.0 spa pack.

On reboot, It is stuck showing the warning message saying check controller cable or update pack software....
There is a regular relay click rom the pack. 

I read in this post "Gecko in.xe stuck in boot loop" by Mattevans, that it could be the low voltage power supply. 

Has anyone done this repair with good result?

Thanks

[Gecko in.xe stuck in boot loop]

Hi Mattevans,

I have the same problem with my Dynasty spa.

Did you manage to fix it?