Mattevans

Thanks Canadian Spa Tech, you also replied to my pm. I appreciate the advice. any suggestions for getting the control board out? unscrewed the 2 screws. but still seems clipped or attached to the housing.

Also unplugged controller and powered up. Same intermittent relay click every 10 to 30 seconds

I have a dynasty spas with a gecko in.xe 5-11-H4.0 spa pak and a touch screen control. Went away for a few days and my kids used the spa a bunch and a flow error was on the control when I checked. Filled the tub, powered off and restarted the tub. Went through startup with no pumps firing for a while then a message showed up saying check controller cable or update pack software or something like that. Powered off unplugged controller and plugged back in and now it is stuck showing the hello logo and initializing forever. There is a regular relay click from the pack. Pulled the 3 fuses and checked continuity and they are good. What would you pros check next?

Have this same boot loop on a gecko in.xe with a touch screen control. The screen sits at initializing, and there is a relay switch every 20 seconds or so. How were you able to repair this?