Robertas
-
Posts
10 -
Joined
-
Last visited
Posts posted by Robertas
-
-
I have checked the jumpers, and they are connected now as it shows on the panel sticker. See photo below. But i have also tried as it shown in manual, and as i understand there is not big difference befween j23 and j32. So yes, everything looks connected right. 😕 The Volt shows 234volt. When i turn it on into the socket. And when it starts circulation pump automaticaly, the volt goes to 233,5. So the voltage probably is okay?. 😕
-
The jumper 91. Does not give any effect on the panel. 😕
-
Yes i am from Europe. If you help me out with thia, i will pay you guys 😕 Cause getting frustrated with these problems
-
The woltage is 240~, as i understand it is okay and it is connected on one cable. Yes the problem is with both panels. And the problem is the same, with old and new panel. I know, that after some time it will work again normally, for some time...
I will check the jumper again today. But as i remember it is on one pin.
I had this jacuzzi before on two incoming cables before. but after using it for a while, we turned it of, and wanted to turn on again. So when i plug one cable, the second cable starts to have electricity. And when i am pluging the second one, it just blows my fuse, as it feel that electricity is coming back trough it when you touch the cable plug. Thats why i connected it to only one cable system. Does this helps a little to find and idea? 😕
-
So it stoped again, just now.. Adding a video. Could anyone help with it? What might be the problem? The circulation pump is still working.. But no buttons reacts when press.
-
Ok, i think it was my bad with last video, cause i switched the pin J83(Cfg) so it has disabled the dip switches. now it is working fine with Celcius and amd the blowers. but again, in the same position at it was, and the dips, are in same position... i think it will stop soon again... 😕
-
Now, it works, on all three sockets, but either it works if i turn on the B6 or turn it off, it is the same 😕 And it started to work differently. Showing in F the degrees, and blower and jet2 do not work. See in video :((
-
Are these okay?
-
Hello, guys! I have a issue with my Hot Tub.
It was working fine after one day, the panel started not to react on any buttton that i press. For example, i press any button, and nothing works, only the panel light starts on pressing the button. I thought the problem is with the panel, so ordered a new one Balboa ML700, the old one was ML551. Changed it, and it was okay for one hour, and same thing happened again. Sometimes it unlags and works normally, but not for long. And sometimes, if i press for example light or jet or other button, it starts to work, but with a delay of 1minute. Mostly it does not work, just panel light turns on. And if i connect and leave it, the circular pump, starts as regulary. Also if i change some DIP switches for example to wrong position, the panel shows that there is a problem with DIP for example CFE A10. But agains freezes (No respond to buttons). All the features works normally, when the panel also works normally. The main board is Balboa GL2000m3. Did anyone had similiar problem? Dont want to buy a mother board, until i know what could be the problem 😕
There are three videos, one will show, that everything sometimes works perfectly, second that sometimes no reaction and third is dip switches and maindboard connections.
I hope somebody could give some solutions!!!! THANK YOU
Kindly, Robertas
Balboa GL series, Panel ML does not respond.
in Portable Hot Tubs & Spas
Posted
j@RDspaguy @CanadianSpaTech
Today it started to work again normally.. 😕 Dont know for how long 😕