tjr
-
Posts
30 -
Joined
-
Last visited
-
Days Won
3
Posts posted by tjr
-
-
To see if circ pump is getting correct voltage set meter to ac voltage and test across terminals on iq box marked circ pump white and black. you should have 120v ac. If you have voltage to pump and it is not working it is defective(rare,but does happen). A lot of times the circ white wire is on wrong terminal.
-
Stop replacing parts. Call a local Hotspring dealer and have them send a mechanic out to DIAGNOSE your problem.
-
No fuses for jet pump. If voltage coming from heater relay board is 220 across red and black and you are not getting 220 across jet pump terminals (doesn't matter if you have 120 to ground at jet pump terminals) you will need a new main board. That board is available from any dealer. Just make sure you have spa serial number since all parts are based on it.
-
Check for 220 across the red and black wires coming of the relay board(blue Board on left). If you have 220 going to main circuit board and your previous post states you only have 120 going to jets you will probably need new main circuit board. you need 220 across jet white and black to run pump or across red and white for low speed.
Hot spring IQ 2000 replacement
in Portable Hot Tubs & Spas
Posted
The 30 amp is only to power the heater everything else runs off the 20 amp gfci. the clicking is from the heater getting too hot and then tripping hilimit. Not that i've ever done it, but did you remove the two clear plastic plugs from the circ pump before install?