Knealy2

Around 103 here in Georgia!

Hey PS, Thanks for the feedback. Pretty sure I got wires hooked up correctly, but anything is possible. I am going to order the new switch and install, and then go from there. Will keep everyone up to date on my progress, in case any others run into the same problem. Thanks Again, Ken

Hey Everyone, Tested the 'Jet Switch' (P/N 32337), it is bad. Got the correct reading on the 'Cleanup Cycle’ switch, so I swapped the wires, but the pump still would not start, so I know there is another problem other than the switch alone, so is it the 'Relay' (P/N 34321) or the "Timing Board (P/N 70821)? Thanks, Ken

Thanks PS! Will test this when it stops raining in Georgia!

Hi Everyone, I have 1996 HotSpring Classic F and am having trouble with the ‘Jets 1’ button. I will not work when depressed. I have removed the control panel and tried pressing the actual “Jet Switch (P/N 32337)”, but still nothing. The ‘Cleanup Cycle’ button works fine and I have been using it to run the hot tub. The Power light is solid and not blinking. My question is: does anyone know if it is a bad ‘Jet Switch’ or possibly the ‘Relay’ inside the control box that might be causing this problem. Also, last time I was inside the control box, there are three relays, two of them look like the 30A (P/N 34321), but the third one has eight prongs instead of the six on 34321, and I can’t seem to find a replacement for it. Hope I have given enough info for someone out there to help. Thanks, Ken