Brian T
-
Posts
29 -
Joined
-
Last visited
Posts posted by Brian T
-
-
Yeah it the control panel or ribbon cable. Had almost all the buttons working at one time except the down which I really needed. Temp was at 104. Somehow got it back to 100 but hardly any buttons working now. Circuit board has 6600-804. Would sure like to find a used one somewhere.
-
I got the controller off. Other than a couple of bugs looked ok. Move some wires around and no change. Sometimes after pressing buttons and than turning tub off and back on the invert and mode change. Is there any kind of reset or default?
-
I started up my 2002 Cameo after sitting down all summer last week. Everything started up fine until a couple of days ago. Came home from work and temp was set at 80. Raised back up to 100. Same thing next night but could not raise. The down button, invert, mode and cycle do not work. Turned tub off and back on and it switched to economy mode and display inverted. Now stuck there. I tried removing the ribbon cable from the board and reseating. Left tub off all night with no help. I am thinking maybe got wet during cleaning or something. Tried to remove display but no sure how to without distroying. I am guessing the cover comes off somehow. There is no access underneth. I got laid off from work yesterday and do not want to spend to much right now. It also seems to have a small leak but will worry about that if I can get controller working. Any ideas?
new recilrc pump tripping gfi breaker
in Portable Hot Tubs & Spas
Posted
I brought my 2002 Sundance Cameo back up after the summer. The recirculation pump would quit and get hot after about 30 minutes. I installed a new pump. Now when I go back out the next day the breaker has tripped. Clamp came loose and some water did drip on it while I was installing it. Could water have gotten in the motor? I was thinking they are pretty waterproof I worked on it some yesterday and was able to get it to trip by switching between standard and economy mode. Breaker would still trip a few seconds after reset. I pulled the while wire on the pump and still tripped breaker. I then pulled the black wire and it reset. Tells me it is shorting to ground sometimes. Put back together and it ran again. It will run a while before tripping. I am thinking of pulling the green ground wire just to see if will run ok without it. Ozone is discounted and temp turned down so as not turn heater on. Not sure where to go from here and don't know if they will replace pump.