ntx

To answer both questions: I had a old cell before and cleaned it still got the same thing. I then purchased a new one and got the same thing so that is why I am asking for help now. I checked the flow switch it looks perfectly fine and it not twisted or bent. It is plumbed horizontal and it's been fine for 8 years it just started doing this.I replaced the board 3 months ago due to a lightning strike and it worked fine till now.

I have a Aqua-Rite chlorinator and the generating light stays on even when the equipment shuts off. The next cycle when it turns on it says low salt and check cell. I unplugged the flow semsor from the bottom of the box and it flashed no flow after a few seconds, so I think it is good. What should I check next?

I have a problem with my Aqua rite as well. I get the generating light stay on even after the equipment turns off. Then the next cycle it says low salt check cell. I assume it stays on and then gets a low salt reading. I tried disconnecting the flow switch from the bottom of box and it gives me a light that says no flow. I assume flow switch is good right? I am out of ideas