Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 11/09/2023 in all areas

  1. Nope... Thank a design engineer. It can be done with a long ratcheting wrench a click and prayer at a time... but honestly remove the 2 front bolts and the plumbing unions at the wet end and use a pry bar to rip the back 2 out. On reinstall just reattach the front 2 to hold it in place and you will be fine.
    1 point
  2. Thank you for your help, it appears that the heater cables were not making very good contact. If wiggled, it would arc. I re-thightened and all is good. Thanks
    1 point
  3. Thanks! I'll see if seller has any more info that could be helpful. It's listed as an identical replacement to my old board, so I'm expecting them to just tell me it's the correct one (and it probably is the correct one).
    1 point
×
×
  • Create New...