shaagtoo Posted July 20, 2014 Report Share Posted July 20, 2014 New member - found this forum online - please excuse this thread if I am not participating properly... I have a one-year old Jandy LRZ heater. It worked fine all winter, but now it won't heat above 94 degrees. It also reports an incorrect water temperature. Other than that, it appears to be working properly. Thanks in advance for any replies...... Quote Link to comment Share on other sites More sharing options...
shaagtoo Posted July 20, 2014 Author Report Share Posted July 20, 2014 Some more info here ... the heater states that the water is 104 degrees (pool is currently 74; spa heated up to 94) ... I have a Jandy remote with a 'temp calibration' feature - it was set to 94 Quote Link to comment Share on other sites More sharing options...
ps0303 Posted July 24, 2014 Report Share Posted July 24, 2014 I'm guessing what you think it says 104, it is actually the temp that the heater is set to. If you have an automation system then it controls the temp, not the heater. In order for it to work this way you have to set the temp on the heater, for both pool and spa, to the highest set point, 104. Maybe your heater is using the pool setting. What is the temp that the pool, on the heater, is set for? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.