Hello
On Nov 28th 2013 I noted LO indicator flashing on my Chlorinator Controller.
Setting was at 20%
Performed Chemistry, Chlorine was off the charts, heavy yellow
Ph was high
Total alkalinity 70
Salinity 3.4
Temp 47 degrees
Prior to removal from service
Flow
Salinity
Temp sensors working properly
Removed from service
Scale build up on probes was observed
Cleaned chlorinator using mix of water and muriatic acid
Returned to service
LO indicator continues to flash.
All sensor points operating normally
Flow and Cell Reversing lights are On
LO continues to flash
Increased Chlorination to 70%
No activity of Chlorinator was noted > No Cell ON indication was created by % increase in chlorine production rate
Turned Power off to controller, waited 5 minutes
Returned to service LO continues to flash and all sensors active.
Cell Reversing light on constantly
Thanks for your assistance.
Todd