Duane Dziewit

Aireators are currently inop as well.

BTW the tub temp is currently at 107F when set at 104F. . An obvious overshoot buy 3 deg F. Set the t/stat to 101F and tem is declining. Any thoughts you can share?

I disconnected the pressure switch from the board and checked the resistance and the reading was .5k ohms. Checked output voltage on the board 5.2vdc. Tapped the heater end where the pressure switch is located a few times. Started the pump on the third attempt the jets started. Repeated many times and jets started. Problem resolved. Thanks again

Had 120v on the board when I disconnected pump and activated jet button. Reconnected terminal connections and had the same result. (Short cycling) The mother board does not have a light plug. Do I need to jumper the pressure switch? See screen shot. The pressure switch is built/wired into the heater.

Is the centrifugal switch and start switch on the mother board? It is putting out 12v.

Had to reseal the heater and refilled the tub. Ozinator, Recirc pump and heater are working and operational. The LCD display appears to be faint and distorted (partly due to water being under temp). 20230804_145717.mp4 Ran jet pump and continues to short cycle/pulsates.

Remove filters and jet pump started early on. Does not work now with or without filters now. Just short cycles or pulsates.

Jet pump is short cycling (pulsating). Replaced the start capacitor and the problem continued. Replaced with new pump and the problem still remains. Vould the control panel cause this or the mother board. Q2000 system...