Lowclass

Also here is a picture of the board on the back side. I think I'll start with the pump. I know it's been sitting empty for acouple of years too. Just gotta wait for the electrician now for the house wiring.

I am thinking the pump is the issue. I can't spin it from the vent side near the shaft.

Ya I understand that. They had it converted to run on 240v which is strictly just heater then. My concern is that when I opened the cover the pump plug was connected to the 0zone port. Now I don't know if this is due to the company they had in their to look at it or not. All components are 120v.

Hi All Looking for some input. I got this hot tub used and have been told it stopped working and they had someone inspect it and said it needs a circuit board. Now when I look into the board I find the pump is plugged into j29 which is for ozone. Not sure why if this was done to drain it maybe or not. Also the dip switch 10 is set to on and should be off for 240v. Should I take my chances once I get the power ran at my house to it and fix the issues I see first or should I replace the board?