FLO error
-
Posts
7 -
Joined
-
Last visited
Posts posted by FLO error
-
-
Before I make a mistake on programming this.
i have
1 2 speed pump
1 1 speed pump
1 circulation pump
1 APG-U. (Advanced Plasma Gap Technology) universal voltage Del ozone
that is an ozanator- correct
-
and then what do I do
-
yes
and I had pump 1 and pump 2 running once..sorry can't remember what LL setting it was on
-
I checked the fuses and they are good. I changed to LL5 and pump 2 still does not work. Then my temperature goes to
----.
I then went to the light key and pressed it
these are all the readings
102 temp
then the time
F5 12
FD 6
FF 2
EP 0
E5 12
ED 6
F
102
temperature is back. Heat is 102 and the circulating pump is running. Pump 1 works on both speeds but pump 2 does not register
-
I tried setting it to LL2 and LL5. The hot tub is now heating, however I can’t get pump 2 to start. When I press pump 2 key nothing happens.
-
Hello
I put in a new circulating pump as I had a FLO error. I have now changed the spa pack and spa control. I put in a IN-XE-5-11-H.0 spa pack and a K450 spa control. I have a 2 speed pump and a 1 speed pump as well as the circulating pump. I set the spa control to LL3 as suggested. I got the spa to heat to 100 degrees but overnight I now a FLO error again. I have removed the air from both pumps and removed both air filters but no luck. I have reset the breaker and tried again but no luck. Any suggestions would be greatly appreciated. I have a Lazy Boy refresh spa.
thanksDave
FLO error
in Portable Hot Tubs & Spas
Posted
Thank you for all your help. I am finally up and running with no problems.
Thanks again