Hello. First time posting but have spent a lot of time over the last day reading. Lots of product expertise here, so I hope you all can assist.
I received a free hot tub from a friend who purchased a house and wanted to pass a tub that came with the house along to someone who would use it. It is a very well maintained Solana X (Model number X1D1677) manufactured 1st quarter of 2002. I spoke to the original owner who said it had been his since new and had taken good care of it. However, he did document the same problem I am experiencing during his last year of ownership, lack of adequate temperature.
Once I got the tub home, I did a system cleaning and implemented a Cleanwater Blue chemical pack that worked quite well. I should note the tub is set up for 115v 15amp. Everything appears to be operating correctly (two-speed pump, heating cycle, etc.) but the tub does not come up to a decent operating water temperature.
Even at its highest setting, the water is never hotter than 99.5 degrees measured with a digital thermometer. The tub appears to run though correct heat cycles (heater/circulation pump on and off).
The tub display shows a consistent three blinking LED display that indicate a flow problem. I have replaced the pressure switch with no effect.
If the tub is running on a heat cycle with the control panel set at a high temperature, I can back the temperature reading on the control panel to below 99 degrees and the heating cycle shuts off.
I've attached some pictures of the circuit board and model numbers.
Thanks in advance for all the help. Worst case I think I can justify a new spa pack if necessary based on the condition of the tub, but wanted to try troubleshooting first. The previous owner had the pump replaced in 2016 or 17.
Mike