Wayned24

How do I make it public?

Any luck with this one? IMG_0571.MOV

This is the big leak when I turn the “jets 2” button on. But when the jets are off, the water level doesn’t drop at all over a 24 hour period. IMG_0571.MOV

Hey everyone. I recently fired up my 2008 Hot Springs Aria.. it had a slow leak that obviously increased with the jets on. I used “Fix a Leak” and it no longer is leaking when the jets are off, but when they turn on, the leak starts again. The water is coming out right by the water feature on the tub. Do those three jets come out? Is there any easier way to fix the leak without taking the panels (Shell) off? Thanks in advance.

I understand that, but I’m just trying to figure it out for my own benefit. I’m having an electrician come..

Wow.. okay.. well I sure am glad I avoided a fatality! So you’re saying I need a 20/20 double pole and a 30/30 double pole breaker in my outdoor box?

Thanks for your response. I was wondering if you could maybe walk me through this diagram? This is what my manual says and I felt like we followed it.

The circulator pump (I think that’s what it is) seems to be working. The little bubbles from the bottom are coming out, but nothing else

Okay.. outside I think I have single pole? There’s a 20amp and a 30amp... they are individual breakers.

The 2 pole is inside. Our electric store didn’t have GFCI breakers.. I know you’re supposed to have them, but would that cause the jets and heat not work?

I’m not sure what a multimeter is? Here are the pictures of the circuit board and the outdoor breaker box.

I can tell you what I remember from yesterday that we did: Installed a 2 pole 50 amp breaker inside by breaker box, ran wire from the breaker to the box outside which has a 20amp and 30amp breaker inside. Then we wired the hot tub and connected it to the outside breaker box. The wire we ran from inside to outside was the correct 240v wire or whatever it’s called.

Well.. I didn’t wire it, my father in law did, he was a maintenance guy for 30 years, so I trusted him, but it’s possible that it’s not wired correctly. He had the diagram of how everything should be. We did hook up 240v..

Following this. My Hot Springs Aria is doing the EXACT same thing.

Hello all. I’m new to the forum. I recently hooked up a 2008 Hot Springs Aria hot tub at my house. It has set for almost two years, but we finally got the power ran to it and it powered up. The lights work, the panel works, radio works, but for some reason, the jets and the heat won’t work? We thought it might be airlocked, so we’ve been trying to troubleshoot that way, but it doesn’t seem to be working. Does anyone have any ideas as to why both the heat and jets don’t work? Thanks!