I have a older tub, which is kept in its own indoor spa / shed.
We get a FLO error at intermittent times.
I have had an Engineer out, who wants us to spend £1200 on a whole new control system. reckons its the circuit board.
When the FLO error comes on - the whole spaform control panel locks out, not even the lights can be switched on / off.
All pumps stop, but give the hot tub a good twenty minutes and it just starts up again as if nothing happened and carries on its merry way.
Trouble is this is getting more frequent. If it was a standard flow error, shouldnt at least one of the pumps carry on working.
When the engineer forced the flo error, by jumper settings - i think or disabling the flo sensor, one pump did carry on. so its very confusing as we get total lock out.
Any ideas