Hi all,
I've got the dreaded blinking red light on my hot springs jetsetter 2.
I tried various diagnostic steps and after hitting test/30seconds/reset on the plug, the pump 'fires up' i.e. is moving water (how much I don't know) and the heater tubes start warming. For about 30seconds then it trips. Sounds like 99% likely to be the circ pump. I took it out and apart & inspected it, removing a nice sized stone in the process, and revealing discolouration (presumably rust), likely from it sitting dry. Cleaned, reattached, no improvement. From these steps and the pictures, it's likely to be a busted circ pump right?
Presuming so, my main question is: which one do I buy? There seems to be a number of options: 3/4" or 1" barb, in 120 or 240v, or a 3/4" 120/240 which is inexplicably cheaper. Looks like the 120/240 3/4" is the E5 whereas the others are E10 options. Am I therefore right in thinking that the Silentflo 5000 replacement E5 is a 3/4" barb so I can go ahead and buy that?
Thanks in advance. Also any strong recommendations of the $199 Watkins OEM version over the $166 Laing non-OEM version?
Cheers all!