Hello all, just purchased a caldera tarino hot tub, and I was wondering if anyone else is familiar with the 220 volt conversion process. It comes wired for 115 volt 20 amp, but may be converted to 230 volt 50 amp. I have removed the jumper at the terminal block as the manual instructs, but it goes on to speak of a "technician" re-configuring the soft jumpers to allow the heater to run at 4k, and jet pump not to run concurrent with heater @30 amp, and run concurrent @ 50amp. There's nothing I can find that elaborates on what soft jumpers to re-configure. If anyone knows I would greatly appreciate if they could direct me in the right direction so i can finish the wiring. Thanks.